Figure 119 Removing And Installing An Expansion Module Esm - Quantum DXi6902 Field Service Manual

Figure 119 Removing and
Installing an Expansion Module
ESM Canister
Expansion Module controller handles
Quantum DXi6902 User's Guide
Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Installing a Replacement Expansion Module ESM
To install the replacement Expansion module ESM canister:
1 Slide the replacement Expansion module ESM canister into the
empty bay until the canister snaps into place, and push the handles
into the closed position (see
2 Connect the SAS cables to the new ESM canister (see
Cabling Diagrams
3 Update the ESM canister firmware:
a Access the Service Menu (see
Menu on page 34).
b Navigate to Hardware Configuration > Setup external
Storage > Upgrade Array Firmware > Upgrade ESM (EBOD)
firmware.
c Follow the prompts to update the ESM firmware. Make sure to
specify the correct Array module and Expansion module.
Replacing an Expansion Module ESM Canister
Figure 119).
on page 211):
Accessing the DXi6902 Service
DXi6902
189