Setting the Environment Heater Switch
CAUTION:
In case that the setting environment is high humidity environment (*), turn on the
Environment Heater Switch.
When the temperature and humidity of the installation environment are high, image
smear is likely to occur.
* This is the case that the value of the absolute water volume outside of the machine is
about 12g or more.
Service Mode (Level1) > COPIER > DISPLAY > ANALOG > ABS-HUM
In case the Environment Heater Switch Cover is included in the package, turn the
Environment Heater Switch ON and then install the Environment Heater Switch Cover.
9
Installation > Installation Procedure > Setting the Environment Heater Switch
1) Remove the Environment Heater Switch Cover.
CAUTION:
When removing the cover, do not insert a screwdriver in the oval hole.
9
Installation > Installation Procedure > Setting the Environment Heater Switch
9-22
F-9-45
9-22