5) Remove the Signal Cable and the Power Cable from the HDD.
x2
6) Put the Signal Cable and the Power Cable aside so that they are not pinched between the
Controller Box and the HDD Unit.
9
Installation > [TYPE-1] > Installation Procedure
Signal Cable
Power Cable
F-9-446
F-9-447
9
Installation > [TYPE-1] > Installation Procedure
7) Remove the HDD Unit by holding it as shown in the figure below.
• 2 Screws
x2
8) Remove the HDD (160GB) installed as standard from the removed HDD Unit. (Removed
HDD (160GB) will not be used.)
• 2 Screws (Removed screw will be used in step 9).)
x2
9-175
F-9-448
F-9-449
9-175