Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1301

2) Connect the cables to the PCB on the backside.
• Signal Cable (450mm (Red)): FK2-8435 or A: Cont-Sig
• Power Cable (430mm): FK2-8463 or A: Cont-Pow
• STS Cable (550mm (Light blue); 5 Pin): FM4-0842 or A: STS-Sig
3) Fix the cables.
• 3 Wire Saddles
• 1 Edge Saddle
• Cable Retainer
Cable Retainer
x3
x4
Wire Saddles
4) Install the Controller Cover. (11 Screws)
9
Installation > [TYPE-5] > Installation Procedure > Installing the Mirroring Board or Encryption Board
Edge Saddle
Power Cable
Signal Cable
STS Cable
F-9-617
9 Installation > [TYPE-5] > Installation Procedure > Installing the Mirroring Board or Encryption Board
5) Connect the cables to the Mirroring Board or Encryption Board.
• Signal Cable (450mm (Red)): FK2-8435 or A: Cont-Sig
• Power Cable (430mm): FK2-8463 or A: Cont-Pow
• LED Cable (1200 mm; 7-pin): FM4-0839 or A: LED-Sig
• STS Cable (550mm (Light blue); 5 Pin): FM4-0842 or A: STS-Sig
CAUTION:
The machine can operate even the STS Cable and the LED Cable are not connected.
Therefore, when installing the cables, be sure that they are connected properly.
x4
9-231
Power Cable
Signal Cable
STS Cable
LED Cable
F-9-618
9-231