Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1406

14) Remove the Power Cable. (Removed Power Cable will not be used.)
<When the Cable Cover is removed>
• 2 Edge Saddles
• 6 Wire Saddles
• 1 Connectors
x1
x8
Power Cable
<When the Cable Cover is not installed>
• 2 Edge Saddles
• 5 Wire Saddles
• 1 Connectors
x1
x7
Power Cable
9
Installation > [TYPE-11] > Installation Procedure > Removing the Signal Cable and Power Supply Cable
Wire Saddle
Connector
Edge Saddle
Wire Saddle
Edge Saddle
Wire Saddle
Connector
Edge Saddle
Edge Saddle
Wire Saddle
9 Installation > [TYPE-11] > Installation Procedure > Removing the Signal Cable and Power Supply Cable
<When the Cable Cover is removed>
15) Remove the 2 Wire Saddles. (Removed wire saddles will not be used.)
F-9-897
16) Remove the HDD Unit by holding it as shown in the figure below. (Removed HDD unit
will not be used.)
• 2 Screws (Removed screw will not be used.)
x2
F-9-898
9-336
F-9-899
F-9-900
9-336