Turning The Main Power On / Setting The Toner Container - Canon imageRUNNER ADVANCE C5255 Series Service Manual

2) Turn ON the Environment Heater Switch.
3) Install the Environment Heater Switch Cover.
9
Installation > Installation Procedure > Turning the Main Power ON / Setting the Toner Container
NOTE:
Only for AUS and CHINA, the Toner Container is installed on the host machine.
1) Connect the power plug of the host machine to the power outlet.
2) Remove the protection sheet on the control panel.
3) Open the switch cover and turn ON the main power switch.
F-9-46
NOTE:
•
•
•
4) After activation, follow the instruction in the Control Panel, and press the shut down key in
the Control Panel.
5) Turn ON the main power switch.
6) Enter the following Service Mode, make sure that the setting value is "1".
• COPIER (Level 1) > OPTION > FNC-SW > W/SCNR
7) Set the value of the following Service Mode.
• COPIER (Level 1) > OPTION > CUSTOM > SCANTYPE
• Setting Value "0" Color Image Reader Unit-F1/F2
• Setting Value "1" Duplex Color Image Reader Unit-E1
F-9-47
8) Exit the Service Mode.
9 Installation > Installation Procedure > Turning the Main Power ON / Setting the Toner Container
Turning the Main Power ON / Setting the Toner
Container
When turning ON the main power, drum initialization and developing assembly
initialization are automatically executed.
In case of the host machine with the Toner Container, toner fill is executed in a row.
Even turning OFF the main power during drum initialization, developing assembly
initialization and toner fill, they will be re-executed when turning ON the power again.
9-23
9-23