Installing The Encryption Board - Canon imageRUNNER ADVANCE C5255 Series Service Manual

Installing the Encryption Board

1) Install the Encryption Board so that "CHA" and "CHB" are placed in the direction of the DC
Controller PCB.
• 4 Screws (TP; M3x6)
CAUTION:
Be sure that the direction of installing the Encryption Board is opposite to the case when
the fixed HDD is installed. If it is installed in a wrong direction, the cables do not reach
the board.
x4
9
Installation > [TYPE-10] > Installing the Encryption Board
CHA
CHB
Direction of the DC Controller PCB
F-9-868
9 Installation > [TYPE-10] > Installing the Encryption Board
2) Connect the cables to the PCB on the backside.
• Power Cable (650 mm): FK2-8464 or A: Cont-Pow (Included in the Removable HDD Kit)
• STS Cable (550 mm (Light blue); 5-pin): FM4-0842 or A: STS-Sig (Included in the HDD
Encryption Kit)
3) Fix the cables.
• 3 Wire Saddles
• 1 Edge Saddle
• Cable Retainer
4) Install the Ring Core to the Power Supply Cable as shown in the figure.
Cable Retainer
Edge Saddle
x2
x4
Wire Saddle
5) Install the Controller Cover. (11 Screws)
9-323
Power Cable STS Cable
F-9-869
9-323