YASKAWA DX200 Maintenance Manual page 1032

Alarm Name
Alarm Sub
Number
Code
5
6
7
8
Meaning Cause
The setting for overlap is Setting error
incorrect.
(1) For a rectangle, it is
incorrectly set as overlap >
width/2.
(2) For a circle, it is incorrectly
set as overlap > ABS (2π *
radius).
(3) For an ellipse, it is
incorrectly set as overlap > π *
radius +ABS (width/2).
other
The setting for the cutting Setting error
speed is incorrect. It is set as
the cutting speed > maximum
linear speed.
other
Coordinated motion cannot be Setting error
used with the Form Cutting
motion.
other
Zero or a negative value is set Setting error
in the minimum diameter
parameter (S1CxG063) for the
Form Cutting motion.
other
Remedy
(1)Check the following settings.
∙
Setting of the overlap data
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Setting of the cutting speed
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Do not use the coordinated motion.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
The setting of the minimum diameter parameter (S1CxG063) for the
Form Cutting motion.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).