YASKAWA DX200 Maintenance Manual page 1031

Alarm Name
Alarm Sub
Number
Code
2
3
4
Meaning Cause
The setting for width is Setting error
incorrect.
(1) For a rectangle, it is
incorrectly set as: width < 1.0,
width > sqrt (maximum
diameter2 - height2), or width
> maximum diameter.
(2) It is incorrectly set as:
width < 0, width > maximum
diameter -2 * radius.
other
The setting for height is Setting error
incorrect.
(1) For a rectangle, it is
incorrectly set as: height >
maximum diameter, height <
minimum diameter/2, or
height > sqrt (maximum
2 2
diameter - width ).
other
The setting for the corner Setting error
radius is incorrect.
(1) For a rectangle, it is
incorrectly set as: corner
radius > width/2 or corner
radius > height/2.
other
Remedy
(1)Check the following settings.
∙
Setting of the width data
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Setting of the height data
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Setting of the corner radius
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).