YASKAWA DX200 Maintenance Manual page 1039

Alarm Name
Alarm Sub
Number
Code
23
24
25
4598 PAINTOUT ERROR 1
4599 SERVO COMMAND
ERROR
4601 UNDEFINED GUN
COND FILE
4603 WIRE STICKING
Meaning Cause
Incorrect designation of the Software operation error
occupation control group for occurred
welding path shift function.
The inverse shift data for Software operation error
welding path shift function occurred
could not correctly be
calculated.
The inverse shift data for Software operation error
welding path shift function occurred
could not correctly be added.
The parameter setting for the Setting error
universal input group number
is incorrect.
other
An attempt was made to issue Software operation error
the command while the servo occurred
control processing has not
completed.
Sub Code: Servo CPU bit
number
Sub Code: Gun condition file Setting error
number
other
Sub Code: Welder number Setting error
Remedy
(1)Reset the alarm, select [UTILITY]-[ARC SHIFT CANCEL], and then
try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, select [UTILITY]-[ARC SHIFT CANCEL], and then
try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, select [UTILITY]-[ARC SHIFT CANCEL], and then
try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Check the following settings.
∙
Check the settings for the AxP011.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Check the following settings.
∙
Complete the gun condition file setting.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Remove the cause of wire stick.