YASKAWA DX200 Maintenance Manual page 1030

Alarm Name
Alarm Sub
Number
Code
4591 SPEED CTRL MODE
SET ERR (SERVO)
4592 SPEED CTRL MODE
CANCEL ERR(SV)
4593 SVHAND CTRL
MODE SET ERR
(SERVO)
4594 SVHND CTRL MODE
CANCEL ERR (SV)
4595 CAN'T DO FIXED 1
FORM CUT MOTION
Meaning Cause
Software operation error
occurred
Software operation error
occurred
Software operation error
occurred
Software operation error
occurred
The setting for radius is Setting error
incorrect.
(1) For a circle, it is incorrectly
set as: radius <= 0, radius <
minimum radius value, or
radius > maximum radius
value.
(2) For an ellipse, it is
incorrectly set as: radius <= 0,
radius < minimum radius
value/2, or radius > (maximum
radius/2 - width/2).
other
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Check the following settings.
∙
Setting of the radius data
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).