YASKAWA DX200 Maintenance Manual page 1022

Alarm Name
Alarm Sub
Number
Code
10
11
12
13
14
15
16
17
Meaning Cause
The laser cutting function Software operation error
(with small circle cutter) is not occurred
used.
The motor gun function (for Software operation error
spot welding application) is occurred
not used.
The speed control function Software operation error
(VCON/VCOF) is not used. occurred
The servo hand function (for Software operation error
handling application) is not occurred
used.
The laser cutting function (for Software operation error
form cutting operation) is not occurred
used.
The series communication Software operation error
function between the systems occurred
(PSEND/PRECV) is not used.
The motion extension function Software operation error
is not used. occurred
The bending function is not Software operation error
used. occurred
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).