YASKAWA DX200 Maintenance Manual page 1060

Alarm Name
Alarm Sub
Number
Code
11
102
4645 NOT PERMIT FIXED-
WEAV ON SWVON
4648 FILE TRANSFER 1
ERROR (ARITH)
2
4649 PARTIAL MOTION
RANGE INTRF.
Meaning Cause
Welding command process Software operation error
exceptional error occurred
The specified welder number Setting error
(system) could not be found.
other
Setting error
other
Motion range file transfer error Setting error
other
Part motion range file transfer Setting error
error
other
Sub Code: Interference Setting error
control group number &
interference axis &
interference area number.
other
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Check the following setting.
∙
Confirm the specified welder number (system) and the setting.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following setting.
∙
Check the settings for jobs.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following setting.
∙
Check if the motion range file is correctly set.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following setting.
∙
Check if the part motion range is correctly set.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following setting.
∙
Check the setting of the teaching position of the manipulator.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).