YASKAWA DX200 Maintenance Manual page 1050

Alarm Name
Alarm Sub
Number
Code
3
4624 PLUG VOLUME
SETTING ERROR
4625 WRONG EXECUTION 1
OF LOADDB INST
2
4
-1
-2
-3
Meaning Cause
The specified step did not Setting error
exist.
other
Setting error
other
No file Software operation error
occurred
No directory Software operation error
occurred
There was no directory entry Software operation error
after this point. occurred
No file name Software operation error
occurred
File presence error Software operation error
occurred
Incorrect file name Software operation error
occurred
Remedy
(1)Check the following settings.
∙
Check the settings for the GETPOS instruction.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Check the setting for the amount of fillings.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).