YASKAWA DX200 Maintenance Manual page 1024

Alarm Name
Alarm Sub
Number
Code
5
6
4567 CANNOT MONITOR
DISTANCE
4568 UNDEFINED PRESS
COND DATA FILE
4569 UNDEFINED PRESS
RESOLUTION DATA
4571 SERVO FLOAT MODE
RELEASE ERR
4572 NO SERVO GUN
CONTROL GROUP
Meaning Cause
Position data error Software operation error
occurred
Setting error of the slave Software operation error
group for user coordinate occurred
conversion
Setting error
other
Sub Code: Press Setting error
characteristic file number
other
Sub Code: Press Setting error
characteristic file number
other
Software operation error
occurred
Setting error
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Check the following settings.
∙
Change the interpolation instruction to MOVL/MOVC.
∙
Change the setting so that the arc retry or restart operation does not
perform.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Set the status of press characteristic file to be used in the job to "Used
State."
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Check the following settings.
∙
Set the press resolution data to be used in the job.
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
(1)Check the following settings.
∙
Set the "motor gun axis" in the control group setting of maintenance
mode.