Cutterbar; Cutterbar Lubrication; Checking Lubricant Level - MacDon R113 Operator's Manual

4.5 Cutterbar

The cutterbar does not require regular maintenance
other than checking and changing the lubricant at regular
intervals. Refer to
4.4.1 Maintenance Schedule/Record,
page 121.
IMPORTANT:
Check the lubricant level when the lubricant is warm.
If the lubricant is cold, idle the machine for about 10
minutes prior to checking.

4.5.1 Cutterbar Lubrication

Checking Lubricant Level

IMPORTANT:
Check the lubricant level when the lubricant is warm. If the lubricant is cold, idle the machine for approximately
10 minutes prior to checking.
1. Park the mower conditioner on level ground.
2. Position header
approximately level.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
3. Shut down the mower conditioner and remove key.
4. Open cutterbar doors.
169820
MAINTENANCE AND SERVICING
so that the cutterbar
Figure 4.32: 13- and 16-Foot Cutterbars
A - 13-Foot Cutterbar
is
Figure 4.33: Cutterbar Doors
136
B - 16-Foot Cutterbar
Revision A