Adjusting The Air Suspension Seat-If Equipped; Adjusting Pilot Control Lever Console Height - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Adjusting the Air Suspension Seat—If
Equipped
While sitting on seat, push down on seat angle lever (1) to
adjust seat to desired angle. Release lever.
Pull up on seat fore-aft handle (2) to unlock seat. Slide seat
to desired distance from control levers. Release handle.
Pull out firmness button (3) to decrease seat firmness.
With key switch in the ON position, press in and hold
firmness button to increase seat firmness.
Pull up on backrest lever (4) to release backrest lock.
Move backrest to desired position. Release lever.
Squeeze lumbar ball (5) to add air for firmness to lower
backrest area. Press button on bottom of lumbar ball to
release air and decrease firmness.
Pull headrest (6) upward or push downward to desired
height. Move headrest to desired angle.
Pull up on armrest (7) to move it out of the way when
exiting the cab.
Turn armrest dial (8) to adjust angle of armrest.
Pull seat and console handle (9) up toward operator. Slide
entire seat and consoles to desired distance from travel
pedals and levers. Release handle.
1— Seat Angle Lever
2— Seat Fore-Aft Handle
3— Firmness Button
4— Backrest Lever
5— Lumbar Ball

Adjusting Pilot Control Lever Console Height

1. Ensure engine is off and pilot shutoff lever is in locked
(UP) position.
CAUTION: Avoid possible crushing injury
from console unexpectedly dropping. Before
loosening the cap screws (1), support the console.
2. Remove right console holding cap screws (1).
3. Loosen cap screw (2) and adjust the pilot control lever
console height relative to the cab floor.
4. Install holding cap screws in holes for desired console
height and tighten.
5. Tighten cap screw to specification.
Specification
Cap Screw—Torque......................................................................50 N·m
Operation—Operator's Station
6— Headrest
7— Armrest
8— Armrest Dial
9— Seat and Console Handle
37 lb·ft
2-1-16
Air Suspension Seat
Adjusting The Armrest
Right Side of Seat Shown
1— Holding Cap Screw (2 used)
6. Repeat procedure for left console.
OUT4001,000077C -19-23FEB12-1/1
2— Cap Screw
OUT4001,000077E -19-19FEB18-1/1
PN=75
092221