Opening And Closing The Polycarbonate-Type Roof Exit Cover; Adjusting The Mechanical Suspension Seat - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Opening and Closing the Polycarbonate-Type
Roof Exit Cover
IMPORTANT: Replace the polycarbonate-type
roof with a new one every 5 years, even if
undamaged. In case polycarbonate-type roof
was visibly damaged or has received severe
shock loads, replace polycarbonate-type roof
even if it has not been in use for 5 years.
When cleaning the polycarbonate-type roof,
use a neutral detergent. If acidic or alkaline
detergent is used, the polycarbonate-type roof
may become discolored or crack.
Keep organic solvent away from
polycarbonate-type roof. Failure to do so
may cause the polycarbonate-type roof to
become discolored or crack.
Opening the Roof Exit Cover:
1. Move lock levers (1) toward center of roof exit.
2. Push on handle (2) to open roof exit cover.

Adjusting the Mechanical Suspension Seat

While sitting on seat, push down on seat angle lever (1) to
adjust seat to desired angle. Release lever.
Pull up on seat fore-aft handle (2) to unlock seat. Slide seat
to desired distance from control levers. Release handle.
Turn weight adjustment knob (3) to adjust seat to weight
of operator.
Squeeze lumbar ball (4) to add air for firmness to lower
backrest area. Press button on bottom of lumbar ball to
release air and decrease firmness.
Pull up on backrest lever (5) to release backrest lock.
Move backrest to desired position. Release lever.
Pull headrest (6) upward or push downward to desired
height. Move headrest to desired angle.
Pull up on armrest (7) to move it out of the way when
exiting the cab.
Turn armrest dial (8) to adjust angle of armrest.
Pull seat and console handle (9) up toward operator. Slide
entire seat and consoles to desired distance from travel
pedals and levers. Release handle.
1— Seat Angle Lever
2— Seat Fore-Aft Handle
3— Weight Adjustment Knob
4— Lumbar Ball
5— Backrest Lever
Operation—Operator's Station
6— Headrest
7— Armrest
8— Armrest Dial
9— Seat and Console Handle
2-1-15
Roof Exit Cover
1— Lock Lever (2 used)
Closing the Roof Exit Cover:
Hold handle and pull roof exit cover down until levers
lock in position.
Mechanical Suspension Seat
Adjusting The Seat
2— Handle
OUT4001,000077B -19-28FEB18-1/1
OUT4001,000077D -19-09FEB12-1/1
PN=74
092221