Service Intervals - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Service Intervals

Model: 380GLC
Hour Meter Reading:
Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement. For example, at 500
hours also service those items (if applicable) listed under 250 hours, 100 hours, 50 hours, and 10 hours or daily.
Fluid samples should be taken from each system at its recommended change interval prior to actually draining the fluid. Regular oil sampling will
extend the operational life of your machine.
□ Remove and clean fuel tank inlet screen
□ Check windshield washer fluid level
□ Check and clean air cleaner dust unloader valve
□ Add coolant extender as indicated by COOL-GARD™ II test strips
□ Check hydraulic tank oil level
□ Check engine coolant level
□ Drain water and sediment from fuel tank sump
□ Drain auxiliary fuel filter and water separator—if equipped
□ Inspect and re-torque track hardware
□ Check swing gear case oil level
□ Check pump drive gear case oil level
□ Check hybrid battery electrolyte level (if equipped)
□ Take engine oil sample
□ Take pump drive gear case oil sample
□ Lubricate swing bearing gear
□ Drain and refill engine oil and replace filter
□ Replace primary fuel filter and water separator
□ Replace auxiliary fuel filter and water separator—if equipped
□ Replace final fuel filter
□ Check air intake hoses
□ Drain and refill swing gear case oil
□ Replace hydraulic tank oil filter
□ Replace pilot oil filter
Maintenance—Periodic Maintenance
PIN/Serial Number:
SERVICE INTERVALS
FLUID SAMPLING
As Required
□ Check and adjust track sag
□ Clean rear camera lens—if equipped
□ Service exhaust filter
□ Clean and tighten battery terminals
Every 10 Hours or Daily
□ Check engine oil level
□ Lubricate hydraulic coupler—if equipped
Every 50 Hours or Weekly
□ Drain primary fuel filter and water separator
□ Lubricate working tool pivots
Every 100 Hours
Every 250 Hours
□ Check travel gear case oil level
□ Drain water and sediment from hydraulic tank
□ Lubricate front end pin joints
Every 500 Hours
□ Lubricate swing bearing
□ Take diesel fuel sample
□ Take swing gear case oil sample
□ Take hydraulic oil sample
□ Take engine coolant sample
□ Take travel gear case oil sample
□ Clean cab fresh air and cab recirculating air filters (replace every
6 cleanings)
Every 1000 Hours
□ Inspect serpentine belt
□ Replace air cleaner elements
□ Replace air cleaner dust unloader valve
Continued on next page
3-2-5
CN93077,000004A -19-06APR20-1/2
092221
PN=146