Replace Final Fuel Filter - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Replace Final Fuel Filter

NOTE: Do not clean fuel tank inlet screen and change
fuel filter at the same time. Clean fuel tank inlet
screen and run engine before changing fuel filter.
1. Ensure key switch is in the OFF position.
2. Open right service door to access final fuel filter (1).
3. Thoroughly clean exterior of final fuel filter and
surrounding area.
NOTE: Some fuel will be present in final fuel filter housing.
4. Remove final fuel filter using a filter wrench. Dispose
of used filter properly.
5. Clean filter mounting base (2).
IMPORTANT: DO NOT prefill fuel filters. Debris
in unfiltered fuel will damage fuel system
components.
Only lubricate filter seal with diesel fuel
before installing.
6. Install new final fuel filter onto mounting base. Rotate
filter housing clockwise by hand. Tighten one turn
after seal contacts mounting base.
7. Prime fuel system and bleed air. See Bleed Fuel
System. (Section 4-1.)
Maintenance—Every 500 Hours
1— Final Fuel Filter
3-8-3
Final Fuel Filter
2— Mounting Base
DB84312,00000E7 -19-27JAN12-1/1
092221
PN=169