Table of Contents
Advertisement
Service Exhaust Filter
CAUTION: Under federal, state, and/or local laws
or regulations, exhaust filter ash may be classified
as a hazardous waste. Hazardous waste must
be disposed of in accordance with all applicable
federal, state and local laws or regulations
governing hazardous waste disposal. Only a
qualified service provider should remove ash
from the exhaust filter. See your authorized dealer
for exhaust filter ash handling and disposal.
The exhaust filter (1) is designed to retain residual ash,
which is a noncombustible result of additives used in
crankcase lubrication oils and the fuel. As ash levels
rise, the capacity for soot storage is reduced. Engine
performance can be reduced due to increased exhaust
system back pressure. The residual ash must be removed
from the filter. Ash removal is performed by removing
the exhaust filter from machine and having it cleaned by
specialized equipment or replacing the exhaust filter.
Do NOT attempt to remove exhaust filter from machine.
Contact your authorized dealer to remove exhaust
filter for ash removal or replacement.
Clean and Tighten Battery Terminals
CAUTION: Battery gas can explode. Keep sparks
and flames away from batteries. Always remove
grounded (-) battery clamp first and replace it last.
1. Disconnect battery clamps, grounded clamp first.
2. Clean terminal (A) and clamp with a stiff brush.
3. Apply lubricating grease (B) where battery terminal
meets top of battery case to prevent grease from
escaping.
4. Install and tighten clamps, grounded clamp last.
Maintenance—As Required
1— Exhaust Filter
Failure to follow the approved ash removal methods may
violate U.S. federal, state and local hazardous waste
laws, along with damage to the exhaust filter resulting in
potential denial of the emissions warranty.
A—Terminal
3-3-4
Exhaust Filter
DB84312,00000EE -19-27JAN12-1/1
Battery Terminal
B—Lubricating Grease
TX,55,FF765 -19-30NOV16-1/1
092221
PN=152
Advertisement
Table of Contents
Troubleshooting
