Mechanical Control Lever Pattern Selector-If Equipped; Operating In Water And Mud - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Mechanical Control Lever Pattern
Selector—If Equipped
The machine pilot control levers can be changed from the
standard EXCAVATOR control pattern (1) to a BACKHOE
control pattern (2). To change control pattern:
1. Park machine on a level surface.
2. Run engine at slow idle speed without load for 3
minutes.
3. Place pilot shutoff lever in the locked (UP) position.
4. Turn key switch to OFF position to stop engine.
Remove key from switch.
5. Open the front left service door to access the
mechanical control lever pattern selector.
6. Remove tie band (3).
7. Remove locking screw (4).
8. Turn selector lever to the standard EXCAVATOR
control pattern or BACKHOE control pattern.
9. Install tie band.

Operating in Water and Mud

Be careful not to operate the machine in water or mud
above the upper deck surface of the undercarriage,
causing the swing bearing and rotary manifold to be
submerged.
If the swing bearing and rotary manifold are submerged,
remove cover from underneath center of machine.
Remove drain plug (1) to drain water and mud.
Clean swing gear area. Install plug and cover. Lubricate
swing gear and swing bearing. See Lubricate Swing
Bearing and Lubricate Swing Bearing Gear. (Section 3-8.)
1— Drain Plug
Operation—Operating the Machine
1— EXCAVATOR Control
Pattern
2— BACKHOE Control Pattern
2-3-18
Mechanical Control Lever Pattern Selector
3— Tie Band
4— Locking Screw
Drain Plug (view from underneath)
ER79617,0000DAC -19-10JAN11-1/1
ER79617,0000DB3 -19-02MAY18-1/1
092221
PN=119