Table of Contents
Related Manuals for Worldwide Construction And Forestry Division 75G
Summary of Contents for Worldwide Construction And Forestry Division 75G
- Page 1 Excavator Operation and Test (PIN: 1FF075GX_ _J015001— ) OPERATION & TEST TECHNICAL MANUAL 75G Excavator (PIN: 1FF075GX_ _J015001— ) TM12873 05JUN19 (ENGLISH) Worldwide Construction And Forestry Division PRINTED IN U.S.A.
- Page 2 Operation and test sections help to quickly of troubleshooting, general maintenance, and basic type identify the majority of routine failures quickly. of failures and their causes. MM16284,00026ED -19-17SEP18-1/1 TM12873 (05JUN19) 75G Excavator 060519 PN=2...
- Page 3 John Deere Dubuque Works 18600 South John Deere Road Attn: Publications, Dept. 324 Dubuque, IA 52004-0538 FAX NUMBER: 1-563-589-5800 (USA) Publication Number: Page Number: Ideas, Comments: Name: Phone: Email Address: THANK YOU! TX,TM,FAX -19-03JUL01-1/1 TM12873 (05JUN19) 75G Excavator 060519 PN=3...
- Page 4 Introduction TM12873 (05JUN19) 75G Excavator 060519 PN=4...
-
Page 5: Group 01-Safety
The right is reserved to make changes at any time without notice. COPYRIGHT © 2019 DEERE & COMPANY Moline, Illinois All rights reserved. A John Deere ILLUSTRUCTION ™ Manual Previous Editions Copyright © 2013, 2014, 2015, 2016, 2017, 2018 TM12873 (05JUN19) 75G Excavator 060519 PN=1... - Page 6 Thanks very much for your reading, Want to get more information, Please click here, Then get the complete manual NOTE: If there is no response to click on the link above, please download the PDF document first, and then click on it. Have any questions please write to me: admin@servicemanualperfect.com...
- Page 7 Contents TM12873 (05JUN19) 75G Excavator 060519 PN=2...
-
Page 8: Table Of Contents
Safely........... 9000-01-12 Service Cooling System Safely ....9000-01-12 Remove Paint Before Welding or Heating ..........9000-01-13 Make Welding Repairs Safely ....9000-01-13 Drive Metal Pins Safely ......9000-01-13 Clean Exhaust Filter Safely ..... 9000-01-14 TM12873 (05JUN19) 9000-1 75G Excavator 060519 PN=1... - Page 9 Contents TM12873 (05JUN19) 9000-2 75G Excavator 060519 PN=2...
-
Page 10: Recognize Safety Information
Know and observe all safety rules that may apply to every supervised training and instruction. work situation and work site. Operator should be familiar with the job site and surroundings before operating. Try all controls and TX,QUALIFIED -19-18JAN11-1/1 TM12873 (05JUN19) 9000-01-1 75G Excavator 060519 PN=9... -
Page 11: Wear Protective Equipment
Contact your authorized John Deere dealer for information on protective guarding. TX,CABGUARD -19-12FEB13-1/1 TM12873 (05JUN19) 9000-01-2 75G Excavator 060519 PN=10... -
Page 12: Inspect Machine
Moline, Illinois, U.S.A., by calling 1-800-822-8262 or +1 If an accident occurs, see a doctor immediately. Any fluid 309-748-5636. injected into the skin must be surgically removed within a few hours or gangrene may result. Doctors unfamiliar DX,FLUID -19-12OCT11-1/1 TM12873 (05JUN19) 9000-01-3 75G Excavator 060519 PN=11... -
Page 13: Avoid High-Pressure Oils
If you do not have an exhaust pipe extension, open the doors and get outside air into the area. DX,AIR -19-17FEB99-1/1 TM12873 (05JUN19) 9000-01-4 75G Excavator 060519 PN=12... -
Page 14: Prevent Fires
Never check battery charge by placing a metal object across the posts. Use a volt-meter or hydrometer. Do not charge a frozen battery; it may explode. Warm battery to 16°C (60°F). DX,SPARKS -19-03MAR93-1/1 TM12873 (05JUN19) 9000-01-5 75G Excavator 060519 PN=13... -
Page 15: Handle Chemical Products Safely
Hazardous waste must cleaning exhaust filter. See your authorized dealer be disposed of in accordance with all applicable for exhaust filter ash handling and disposal. federal, state, and local laws or regulations TX,ASH,DISP -19-20JAN11-1/1 TM12873 (05JUN19) 9000-01-6 75G Excavator 060519 PN=14... -
Page 16: Prepare For Emergencies
Never attempt to start engine from the ground. Do not attempt to start engine by shorting across the starter solenoid terminals. TX,SOFOS -19-20JAN11-1/1 TM12873 (05JUN19) 9000-01-7 75G Excavator 060519 PN=15... -
Page 17: Use And Maintain Seat Belt
Always lower work equipment to the ground and pull pilot shutoff lever to locked (UP) position before standing up or leaving the operator's seat. Stop engine before exiting. JS93577,0000073 -19-14JAN13-1/1 TM12873 (05JUN19) 9000-01-8 75G Excavator 060519 PN=16... -
Page 18: Avoid Work Site Hazards
Riders are subject to injury. They may fall from machine, be caught between machine parts, or be struck by foreign objects. Riders may obstruct operator’s view or impair his ability to operate machine safely. JS93577,00001E5 -19-16JAN13-1/1 TM12873 (05JUN19) 9000-01-9 75G Excavator 060519 PN=17... -
Page 19: Avoid Backover Accidents
• Check ROPS for cracks or physical damage. bending, drilling, or cutting. If ROPS was loosened or removed for any reason, inspect it carefully before operating the machine again. TX,ROPS -19-20JAN11-1/1 TM12873 (05JUN19) 9000-01-10 75G Excavator 060519 PN=18... -
Page 20: Avoid Machine Tip Over
Ensure that a qualified person is involved in attachment installation. Add guards to machine if operator protection TX,ATTACH -19-20JAN11-1/1 TM12873 (05JUN19) 9000-01-11 75G Excavator 060519 PN=19... -
Page 21: Park And Prepare For Service Safely
Shut off engine. Only remove filler cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. DX,RCAP -19-04JUN90-1/1 TM12873 (05JUN19) 9000-01-12 75G Excavator 060519 PN=20... -
Page 22: Remove Paint Before Welding Or Heating
Hammering hardened metal parts such as pins and bucket teeth could dislodge chips at high velocity. Use a soft hammer or a brass bar between hammer and object to prevent chipping. TX,PINS -19-20JAN11-1/1 TM12873 (05JUN19) 9000-01-13 75G Excavator 060519 PN=21... -
Page 23: Clean Exhaust Filter Safely
Always disable movement (neutral), set the parking brake or mechanism and disconnect power to attachments or tools before leaving the operator’s station. Shut off engine and remove key (if equipped) before leaving the machine unattended. DX,EXHAUST,FILTER -19-12JAN11-1/1 TM12873 (05JUN19) 9000-01-14 75G Excavator 060519 PN=22...