Replace Hydraulic Tank Vent Cap Filter - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Replace Hydraulic Tank Vent Cap Filter

Pressurized Fluids
CAUTION: High pressure release of oil from
pressurized system can cause serious burns
or penetrating injury. Relieve by pushing
pressure release button (1).
To prevent possible burn injury from hot
hydraulic oil, wait for hydraulic oil to cool
before starting work.
1. Park machine on solid level surface as shown. Stop
engine.
2. Push the pressure release button (1) on top of the
hydraulic tank oil cover with suction screen (5).
3. Remove rubber pressure release button.
4. Remove cap screw under the pressure release button.
5. Remove hydraulic tank vent cap filter cover (2) by
turning counterclockwise.
6. Remove vent cap filter (3). Install new filter.
IMPORTANT: Prevent damage to hydraulic
system components. Do not allow water or
contaminants between cover and body (4).
7. Install filter cover until it comes in contact with the filter
element. Then, further tighten the cover 1/4 turn.
8. Install cap screw and pressure release button.
1— Pressure Release Button
2— Hydraulic Tank Vent Cap
Filter Cover
3— Vent Cap Filter
Maintenance—Every 5000 Hours
4— Body
5— Hydraulic Tank Oil Cover
With Suction Screen
3-11-3
Machine Position
Hydraulic Tank Oil Cover
Hydraulic Tank Oil Vent Cap
DB84312,000014A -19-05JUN14-1/1
092221
PN=183