Replacing Bucket Tooth Tip-Heavy-Duty Bucket; Replacing Bucket Teeth-Tk Series - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Replacing Bucket Tooth Tip—Heavy-Duty
Bucket
1. Clean tooth (A) and tooth tip (B).
2. Insert lock removal tool under U-shaped pin (C).
CAUTION: Avoid possible injury. Pin may fly
after pin is released from tooth tip. Keep a
firm grip on pin to prevent injury.
3. Remove pin.
4. Turn tooth tip counterclockwise and pull tooth tip up
to remove.
5. Clean tooth shank.
6. Replace U-shaped pin and tooth tip at the same time.
7. Insert tooth tip on shank turning tip clockwise.
8. Install U-shaped pin. The side of the pin with the
FRONT mark (D) must face tooth tip. Make sure pin is
firmly engaged over tooth tip.
A—Tooth
B—Tooth Tip
Replacing Bucket Teeth—TK Series
IMPORTANT: Prevent machine damage. Check
bucket teeth periodically so that wear does
not extend to the bucket tooth shank.
1. Remove pin (1) by rotating counterclockwise 180°
using a ratchet and socket.
2. Remove tooth.
3. Inspect pin and rubber locks (2) for damage. Replace
if necessary.
4. Position the new tooth over the tooth shank.
5. Install pin by rotating clockwise 180°. Install pin in
same orientation as removed. Check alignment of pin.
1— Pin
Miscellaneous—Machine
C—Pin
D—FRONT Mark
2— Rubber Lock (2 used)
4-1-13
Bucket Tooth Tip
U-Shaped Pin
04T,90,K273 -19-30MAR16-1/1
Pin
Rubber Lock
DB84312,00000BC -19-24OCT18-1/1
092221
PN=198