Engine - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Table of Contents

Advertisement

Engine

Symptom
Engine Cranks But Will Not Start
Or Hard To Start
Engine Will Not Crank
Engine Knocks, Runs Irregularly,
Or Stops
Miscellaneous—Troubleshooting
Problem
No fuel
Incorrect fuel
Fuel filters restricted
Primary fuel filter and water separator
restricted or not primed
Water in fuel tank
Low battery power
Slow cranking speed (poor electrical
connection)
Incorrect engine oil
Fuel filter not installed correctly
Low battery power
Corroded or loose battery connections Clean battery terminals and
Fuse
Air filters restricted or dirty
Fuel filters restricted
Air in fuel system
Contaminated fuel
Engine speed control system
Fuel filter not installed correctly
Continued on next page
4-3-2
Solution
Add correct fuel. Bleed air.
Drain fuel tank and refill with correct
fuel.
Replace filters. Bleed air. Clean fuel
tank inlet screen.
Check primary fuel filter and water
separator. Replace filter, prime filter,
and bleed air from fuel system.
Check, drain, and refill.
Charge or replace battery.
Clean and tighten battery and starter
connections.
Drain crankcase and refill with correct
oil.
Install new filter and O-ring. Ensure
proper O-ring seal. Bleed air.
Charge or replace battery.
connections.
Check ECU fuse (F8) and POWER
ON 5 amp fuse (F17).
Clean or replace filter elements.
Replace filters. Bleed air. Clean fuel
tank inlet screen.
Bleed air from fuel system.
Drain fuel tank. Change primary fuel
filter and water separator. Bleed air.
Add clean fuel.
See your authorized dealer.
Install new filter and O-ring. Ensure
proper O-ring seal. Bleed air.
CN93077,0000024 -19-03JUN14-1/3
092221
PN=252

Advertisement

Table of Contents
loading

Table of Contents