Drain And Refill Engine Oil And Replace Filter - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Drain and Refill Engine Oil and Replace Filter

IMPORTANT: Avoid engine damage. Make sure that
area around and above engine oil filler cap is
clean and clear of debris before removing cap.
1. Run engine to warm oil.
2. Park machine on a level surface.
3. Stop engine.
4. Remove middle access cover under the machine.
Open drain valve on side of engine oil pan. Allow oil to
drain into a container. Dispose of waste oil properly.
5. Close drain valve and install access cover.
6. Turn filter (3) counterclockwise to remove. Clean
mounting surface on base.
7. Apply thin film of oil to rubber gasket of new filter.
8. Install new filter. Turn filter clockwise by hand until
gasket touches mounting surface.
9. Tighten filter 1/2—3/4 turn more.
10. Remove filler cap (2) and fill engine with oil. For
specific engine oil, see applicable Diesel Engine Oil
story. (Section 3-1.)
Specification
Engine Oil With
Filter—Capacity.............................................................................. 27.0 L
11. Install filler cap.
12. Start engine.
13. Stop engine, remove dipstick (1) and check oil level.
Engine is full when oil level is in the cross-hatch area.
14. Check for any leakage at filter. Tighten filter just
enough to stop leakage.
Maintenance—Every 500 Hours
7.2 gal.
1— Dipstick
2— Filler Cap
3-8-5
Engine Oil Filter
Engine Oil Dipstick and Filler Cap
3— Engine Oil Filter
DB84312,00000EA -19-05JUN14-1/1
092221
PN=171