Clean Rear Camera Lens-If Equipped; Check Coolant - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Clean Rear Camera Lens—If Equipped
CAUTION: Avoid personal injury. DO NOT
climb on machine when inspecting or
cleaning rear camera lens.
NOTE: The camera lens surface is a resin product.
Lightly wipe the surface with a wet, clean cloth.
Never use an organic solvent.
Inspect camera lens (1) for any accumulation of dirt, mud,
snow, ice, or debris.
Clean lens as necessary.
1— Camera Lens

Check Coolant

CAUTION: Prevent possible injury from hot
spraying fluids. Shut off engine. Remove filler
cap only when cool enough to touch with bare
hands. Slowly loosen cap to relieve pressure
before removing completely.
IMPORTANT: John Deere COOL-GARD™ II
Coolant Extender does not protect against
freezing. Coolant extender prevents rust,
scale, and liner cavitation.
NOTE: Check coolant every 1000 hours or 1 year,
or when replacing 1/3 or more of coolant. Add
coolant extender as indicated by John Deere
COOL-GARD™ II test strips.
1. Open engine cover. Remove surge tank cap (1) and
test coolant solution. Use the following kit to check
coolant:
•
COOL-GARD II Test Strips
Coolant test strips provide an effective method to
check freeze point and additive levels of engine
coolant. See your authorized dealer for COOL-GARD
II test strips and follow instructions on kit.
Specification
Cooling System—Capac-
ity.................................................................................................... 39.7 L
2. Add John Deere COOL-GARD II Coolant Extender
as necessary. Follow instructions on container for
amount.
3. Install surge tank cap.
COOL-GARD is a trademark of Deere & Company
Maintenance—As Required
1— Surge Tank Cap
10.5 gal.
4. Close engine cover.
3-3-3
Rear Camera
ER79617,0000D75 -19-27JUL15-1/1
Service Cooling System Safely
Surge Tank
DB84312,00000E1 -19-21MAR13-1/1
092221
PN=151