Wear Protective Equipment; Avoid Unauthorized Machine Modifications; Control Pattern Selector-If Equipped; Add Cab Guarding For Special Uses - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Wear Protective Equipment

Guard against injury from flying pieces or metal or debris;
wear goggles or safety glasses.
Wear close fitting clothing and safety equipment
appropriate to the job.
Operating equipment safely requires the full attention of
the operator. Do not wear radio or music headphones
while operating machine.
Prolonged exposure to loud noise can cause impairment
or loss of hearing. Wear suitable hearing protection such
as earmuffs or earplugs to protect against objectionable or
uncomfortable loud noises. Radio or music headphones
are not suitable to use for hearing protection.

Avoid Unauthorized Machine Modifications

John Deere recommends using only genuine John Deere
replacement parts to ensure machine performance.
Never substitute genuine John Deere parts with alternate
parts not intended for the application as these can
create hazardous situations or hazardous performance.
Non-John Deere parts, or any damage or failures resulting
from their use are not covered by any John Deere warranty.
Modifications of this machine, or addition of unapproved
products or attachments, may affect machine stability or
Control Pattern Selector—If Equipped
This machine may be equipped with a control pattern
selector valve. Ensure all bystanders are clear of machine

Add Cab Guarding for Special Uses

Special work situations or machine attachments could
create an environment with falling or flying objects.
Working near an overhead bank, demolition work, using
a hydraulic hammer or winch, working in a forestry
application or wooded area, or working in a waste
management application, for example, could require
added guarding to protect the operator.
Safety—General Precautions
reliability, and may create a hazard for the operator or
others near the machine. The installer of any modification
which may affect the electronic controls of this machine is
responsible for establishing that the modification does not
adversely affect the machine or its performance.
Always contact an authorized dealer before making
machine modifications that change the intended use,
weight or balance of the machine, or that alter machine
controls, performance or reliability.
and area is large enough to operate machine functions.
Verify the machine response to each control movement.
Additional level II FOPS (falling object protective
structure), forestry protection packages, and special
screens or guarding should be installed when falling
or flying objects could enter or damage the machine.
A rear screen should always be used with a winch to
protect against a snapping cable. Before operating in any
special work environments, follow the operator protection
recommendations of the manufacturer of any specialized
attachment or equipment. Contact your authorized John
Deere dealer for information on protective guarding.
1-2-2
TX,WEAR,PE -19-16JUN21-1/1
AM40430,00000A9 -19-20AUG09-1/1
TX,CTRL,PAT,IFEQUIP -19-24FEB20-1/1
TX,CABGUARD -19-12FEB13-1/1
092221
PN=31