Operate Within Machine Limits; Travel Pedals And Levers - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Operate Within Machine Limits

IMPORTANT: Prevent boom, arm, and bucket cylinder
damage. Operating machine with any cylinder at
end of stroke (1) may apply excessive load which
may damage the cylinders. Avoid operating
machine with any cylinder at end of stroke.
When an excessive load is applied to the boom, arm, or
bucket, hydraulic oil is relieved in those circuits. Relieving
oil reduces hydraulic circuit pressure and load on the
components to protect the machine from damage. If the
cylinders are used at the end of stroke (1), the force is
applied to the cylinders and machine components are no
longer protected by the relief valve. Do not operate the
machine with any cylinder at the end of stroke.

Travel Pedals and Levers

CAUTION: Prevent possible injury from
unexpected machine movement. Keep
bystanders clear of machine when traveling.
Keep bystanders clear of machine when traveling.
The instructions below apply when the travel motors (4)
are to the rear of the machine. If the travel motors are to
the front of the machine, the machine moves OPPOSITE
to the direction described.
FORWARD TRAVEL (1): Push down on front of both
pedals or push both levers forward.
REVERSE TRAVEL (2): Push down on rear of both
pedals or pull both levers rearward.
NEUTRAL POSITION (3): Travel brakes will automatically
stop and hold the machine.
RIGHT TURN: Push down on front of left pedal or push
left lever forward.
LEFT TURN: Push down on front of right pedal or push
right lever forward.
SHORT TURN (COUNTER ROTATE): Push down the
front of one pedal and the rear of the other or push one
lever forward and pull the other rearward.
CAUTION: Prevent possible injury from machine
tipping. Operate control pedals or levers slowly
when traveling down a slope.
TRAVELING DOWN A SLOPE: Operate control pedals or
levers slowly when traveling down a slope.
Operation—Operating the Machine
1— End of Stroke
1— Forward Travel
2— Reverse Travel
COLD WEATHER OPERATION: Travel pedal and lever
dampers are provided for smooth control. In extremely
cold weather, pedal or lever effort will increase. Operate
pedals or levers several times with pilot shutoff lever in the
locked (UP) position.
2-3-6
1
1
Operate Within Machine Limits
Travel Pedals and Levers
3— Neutral Position
4— Travel Motor (2 used)
TX,CYLINDER,LIMITS -19-08JAN21-1/1
ER79617,0000E31 -19-04MAY15-1/1
092221
PN=107