Prepare Machine For Maintenance - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Prepare Machine for Maintenance

Before performing maintenance procedures in the
following chapters and before leaving operator's seat,
park machine as described below unless another position
is specified in the procedure.
1. Park machine on a level surface as shown.
2. Lower equipment to the ground.
3. Turn auto-idle switch (1) to the A/I OFF position.
IMPORTANT: Turbocharger can be damaged
if procedure to shut down engine is
not done properly.
4. Run engine with engine speed dial (2) at 1/3 position
without load for 2 minutes.
5. Turn engine speed dial to slow idle position.
6. Turn key switch (3) to the OFF position. Remove key
from switch.
7. Place pilot shutoff lever (4) to locked (UP) position.
1— Auto-Idle Switch
2— Engine Speed Dial
Maintenance—Periodic Maintenance
3— Key Switch
4— Pilot Shutoff Lever
3-2-2
Machine Position
Switch Panel
Pilot Shutoff Lever
ER79617,0000D96 -19-17OCT17-1/1
092221
PN=143