Worldwide Construction And Forestry Division 380GLC Operator's Manual page 113

If a problem occurs during the programming process, a
red program failure alarm will appear on the monitor along
with a red warning alarm. The message on the monitor
will state:
PROGRAM FAILURE
If these alarms appear, see an authorized John Deere
dealer for solutions.
If conditions exist that will not allow the transfer of new
software to happen, a red unable to program alarm
appears on the monitor along with a yellow warning alarm.
The message on the monitor will state:
UNABLE TO REPROGRAM DEVICE
Make sure the engine is stopped and pilot shutoff lever
is in locked (UP) position. Press and hold the right side
of SAR switch (green LED) again for 3 seconds to retry
programming or contact an authorized John Deere dealer.
Operation—Operating the Machine
TX1087189 —UN—21JAN11
Program Failure Alarm
TX1087190 —UN—21JAN11
Unable to Program Alarm
2-3-12
TX1086352 —UN—06JAN11
Warning Alarm
TX,SAR,OPERATION,1 -19-13JUL20-2/3
TX1086352 —UN—06JAN11
Warning Alarm
TX,SAR,OPERATION,1 -19-13JUL20-3/3
PN=113
092221