Maintenance-Every 10 Hours Or Daily; Check Engine Oil Level - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Maintenance—Every 10 Hours or Daily

Check Engine Oil Level

IMPORTANT: Prevent engine damage. Do not run
engine when oil level is below the ADD mark.
The most accurate oil level reading is obtained when the
engine is cold before starting the engine for the day's
operation.
1. Park machine on a level surface.
2. Shut off engine and allow oil to drain into oil pan for
10 minutes.
3. Open engine cover to access engine.
4. Make sure dipstick (1) is fully seated.
5. Remove dipstick to check oil level.
BEFORE THE ENGINE IS STARTED: The engine
is full when oil level is in the cross-hatch area (3). It
is acceptable to run the engine when the oil level is
above the ADD mark.
AFTER THE ENGINE HAS BEEN RUN: Allow the oil
to drain into the oil pan for 10 minutes before checking
the oil level. Ten minutes after shutdown the engine oil
level must be above the ADD mark.
IMPORTANT: Avoid engine damage. Make sure that
area around and above engine oil filler cap is
clean and clear of debris before removing cap.
6. If necessary, remove filler cap (2) to add oil.
7. If oil level is below ADD mark, add oil as necessary.
See Diesel Engine Oil. (Section 3-1.)
8. Install dipstick and close engine cover.
1— Dipstick
2— Filler Cap
3— Cross-Hatch Area
3-4-1
Engine Oil Dipstick and Filler Cap
3
ADD FULL
Cross-Hatch Area
CN93077,000001A -19-05SEP12-1/1
092221
PN=153