Worldwide Construction And Forestry Division 380GLC Operator's Manual page 230

Swing Dynamic Braking
Check
TX1095482 —UN—28JUN13
TX1086753 —UN—11JAN11
1— Engine Speed Dial
2— Auto-Idle Switch
3— Travel Speed Switch
4— Power Mode Switch
Position upperstructure with boom to the front.
Move arm to the extended position, bucket to the retracted position, and bucket-to-arm
pivot pin at same level as boom-to-frame pivot pin.
Turn engine speed dial (1) to H (fast idle) position.
Press power mode button (4) until PWR (power) mode is displayed on monitor.
Fully actuate swing function. Swing clockwise 90 degrees and then release lever.
LOOK: Does upperstructure stop within 45 degrees (1/8 turn) or less after releasing
lever?
Position upperstructure with boom to the front.
Fully actuate swing function. Swing counterclockwise 90 degrees and then release
lever.
LOOK: Does upperstructure stop within 45 degrees (1/8 turn) or less after releasing
lever?
Miscellaneous—Operational Checkout
45˚
90˚
Swing Dynamic Braking
INT
ON
OFF
PUSH
1 2 3 4 5 5
6 7 8 9 0
CAUTION: Avoid possible injury. Make sure area is clear and large enough
to swing extended arm and bucket. Machine must be on level ground.
4-2-25
PUSH
MENU/SET
PUSH
MODE
PUSH
TUNE/AM-FM
PUSH
/VOL
/PWR
H
L
PUSH
VOL/PWR
min -1
1
L H
2
A/I
A/I
ON
OFF
OFF
3
MODE OFF
1
2
4
Switch Panel
Continued on next page
YES: Go to next check.
NO: See your authorized
dealer.
CN93077,000003A -19-16MAY13-32/53
092221
PN=230