Clean The Machine Regularly; Adding 12-Volt Accessories; Jdlink™ Machine Monitoring System (Mms)-If Equipped - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Clean the Machine Regularly

CAUTION: Avoid personal injury from flying
debris. Be careful when removing any grease,
oil, fuel, or debris buildup.
IMPORTANT: Directing pressurized water at
electronic/electrical components or connectors,
bearings and hydraulic seals, fuel injection
pumps or other sensitive parts, and components
may cause product malfunctions. Reduce
pressure and spray at a 45—90° angle.
High-pressure washing (greater than 1379 kPa [13.8 bar]
[200 psi]) can damage freshly painted finishes. Paint
should be allowed to air-dry for 30 days minimum after
receipt of machine before cleaning with high pressure. Use
low-pressure wash operations until 30 days have elapsed.

Adding 12-Volt Accessories

IMPORTANT: This machine has a 24-volt electrical
system. Installing 12-volt accessories without
the addition of 24-volt-to-12-volt converter
may cause battery malfunction.
This machine is equipped with a 12-volt,
5-amp outlet.
When possible, use 24-volt accessories. If 12-volt
accessories are added, use a 24-volt-to-12-volt converter.
Converters are available from an authorized John Deere
dealer.
Converter capacity requirements depend on the load
of the accessories installed. Follow electronic dealer
JDLink™ Machine Monitoring System
(MMS)—If Equipped
JDLink™ is an equipment monitoring and information
delivery system. JDLink™ automatically collects and
manages information about where and how construction
JDLink is a trademark of Deere & Company
Miscellaneous—Machine
Do not spray heat exchangers at an angle.
and manufacturer's recommendations to determine the
capacity of the converter required and its installation
requirements. If standard equipment, verify if amperage
is adequate for application.
IMPORTANT: DO NOT connect an accessory to one
battery. Connecting a 12-volt accessory to one
battery will cause one battery to overcharge
and the other battery to undercharge,
causing battery malfunction.
and forestry equipment is being used, as well as critical
machine health data and service status.
For more information, see an authorized John Deere
dealer or visit www.deere.com (browse to Construction,
Services and Support, JDLink™).
4-1-8
Clean Machine Regularly
ER79617,0000D50 -19-31MAR16-1/1
TX,90,DH3734 -19-21FEB18-1/1
VD76477,0001541 -19-26MAR15-1/1
092221
PN=193