Worldwide Construction And Forestry Division 380GLC Operator's Manual page 217

Windshield Wiper Circuit
Check
TX1001270 —UN—14DEC05
1— Lock Pin
2— Lock Release Bar
NOTE: The wiper cannot operate with the upper front window open. The washer
Slide lock pin (1) inward, then down into notch.
Pull lock release bar (2) toward operator's seat.
While holding lower handle on window, pull window up and back as far as it can go.
Slide lock pin into cab frame boss hole and rotate downward into the locked position.
TX1086748 —UN—11JAN11
4— Windshield Wiper and Washer Switch
Turn windshield wiper and washer switch (4) ON.
Miscellaneous—Operational Checkout
2
Front Window Release Handle
CAUTION: Prevent possible injury from window closing. Upper front
window comes down very forcefully. Close window only when sitting
on operator's seat. Guide window down slowly.
CAUTION: Prevent possible injury from window closing. Always
lock the pin in cab frame boss hole.
can operate with the upper front window open. When closing window, check
that window upper left corner makes good contact with the cab.
INT
ON
OFF
4
PUSH
1 2 3 4 5 5
6 7 8 9 0
4-2-12
1
PUSH
MENU/SET
PUSH
MODE
PUSH
TUNE/AM-FM
PUSH
/VOL
/PWR
H
L
PUSH
VOL/PWR
min -1
L H
A/I
A/I
ON
OFF
OFF
MODE OFF
1
2
Switch Panel
Continued on next page CN93077,000003A -19-16MAY13-16/53
092221
PN=217