Bucket Remove And Install; Continued On Next Page - Worldwide Construction And Forestry Division 380GLC Operator's Manual

Bucket Remove and Install

SPECIFICATIONS
Bucket Link and Arm End Play
Split O-Ring Seal Nut Torque
Split O-Ring Seal Retainer Cap
Screw Length
PIN WEIGHT SPECIFICATIONS (APPROXIMATE)
130G Bucket Pin Weight
160GLC, 180GLC, 200G, 210G,
and 210GLC Bucket Pin Weight
250GLC, 290GLC, and 300GLC
Bucket Pin Weight
350GLC and 380GLC Bucket Pin
Weight
470GLC Bucket Pin Weight
REMOVAL
1. Park and prepare machine for service safely. See
Prepare Machine for Maintenance. (Section 3-2.)
CAUTION: Prevent possible crushing injury from
heavy component. Bucket could possibly roll.
Secure bucket position with appropriate blocking.
2. Position bucket flat side down and use appropriate
blocking to stabilize.
3. Remove nuts (4) and cap screws (3).
CAUTION: Prevent possible crushing injury from
heavy component. Use appropriate lifting device.
4. Use appropriate lifting device to remove bucket
link pin (1) and bucket arm pin (2). See pin weight
specification table for approximate bucket pin weights.
5. Separate bucket from arm and link.
6. Remove 2MAD™ seals, O-ring seals, or split O-ring
seals. Clean, inspect, and replace as necessary.
2MAD is a trademark of ESP International
Miscellaneous—Machine
0.5—1.5 mm
0.020—0.060 in
6 N·m
53 lb·in
10—20 mm
0.394—0.787 in
12 kg
26 lb
20 kg
44 lb
34 kg
75 lb
46 kg
101 lb
61 kg
134 lb
4-1-14
Bucket Arm and Bucket Link Pins
1— Bucket Link Pin
2— Bucket Arm Pin
3— Cap Screw (2 used)
IMPORTANT: Prevent possible damage to pins,
bushings, and bosses. Dirt and debris can
prematurely wear components. Clean all
components thoroughly.
7. Clean contaminated grease, dirt, and debris from
bucket link pin and bucket arm pin pivot areas.
8. Inspect dust seals (7) for wear or damage. Replace as
necessary.
9. Inspect pins and bushings for wear or damage.
Replace as necessary.

Continued on next page

Dust Seal
4— Nut (4 used)
7— Dust Seal (4 used)
DH10862,0000008 -19-07MAY20-1/4
092221
PN=199