Table of Contents
Advertisement
2. Move the retaining clip from the appropriate power cord on the rear
panel of the chassis, and disconnect the cord. Refer to Figure 109.
Figure 109. Disconnecting the AC Power Cord from the Chassis
3. Lift the locking hand on the power supply. Refer to Figure 110.
Figure 110. Lifting the Locking Handle on the SBxPWRSYS2 AC Power
4. Carefully pull on the locking handle to slide the power supply from the
chassis. Refer to Figure 111 on page 190.
SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Supply
189
Advertisement
Table of Contents
