Figure 44: Disconnecting The Power Cord From An Ac Power Source - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 6: Verifying the Status of the Switches
90
Figure 44. Disconnecting the Power Cord from an AC Power Source
8. Repeat this procedure on the second switch.
9. Once you have confirmed that the VCStack feature is enabled on both
switches of the stack, do one of the following:
 If you want to confirm that the switches have the same version of
management software and feature licenses, go to "Starting a Local
Management Session" on page 91 and then "Comparing the
AlliedWare Plus Version Numbers and Feature Licenses" on
page 95.
 Otherwise, go to Chapter 7, "Installing the Stacking QSFP+
Transceivers" on page 99.