Installing Ethernet Line Cards; Figure 56: Removing A Blank Line Card Cover - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Advanced layer 3+ modular switch alliedware plus v5.4.9-2, virtual chassis stacking
Hide thumbs Also See for SwitchBlade x908 GEN2:
Table of Contents

Advertisement

Installing Ethernet Line Cards

This section contains the procedure for installing Ethernet line cards in the
chassis. The illustrations show the XEM2-12XT Line Card. The procedure
is the same for all line card models.
Caution
The device can be damaged by static electricity. Be sure to follow
proper anti-static precautions when installing the device. Allied
Telesis recommends using a properly grounded wrist strap or other
personal anti-static device and an anti-static mat.
To install Ethernet line cards, perform the following procedure:
1. Choose a slot in the chassis for the card. You can install cards in slots
1 to 8.
2. If the slot is covered with a blank panel, use a #2 Phillips-head
screwdriver to loosen the two captive screws on the panel and remove
it from the chassis. Refer to Figure 56.
Figure 56. Removing a Blank Line Card Cover
SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
109

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sbx908 gen2

Table of Contents