Replacing Pwr600 Ac Power Supplies; Figure 96: Disconnecting The Ac Power Cord From The Power Source - Allied Telesis AlliedWare Plus x950 Series Installation Manual

Replacing PWR600 AC Power Supplies

This section contains the procedure for removing or replacing PWR600
AC Power Supplies.The following illustrations show the removal of a
power supply from slot PSU A. The procedure is the same for slot PSU B.
Note
Allied Telesis recommends saving a backup copy of the
configuration file in the switch before removing or replacing power
supplies. For instructions, refer to the Software Reference for AT-
x950 Switches.
To remove power supplies from the switch, perform the following
procedure:
1. Disconnect the AC power cord for the power supply from the AC power
source. Refer to Figure 96.
Figure 96. Disconnecting the AC Power Cord from the Power Source
2. Open the restraining strap on the power cord by pressing down on the
release tab and pulling out the strap. Refer to Figure 97 on page 190.
x950 Series Installation Guide for VCStack
189