Table of Contents
Advertisement
Chapter 8: Replacing Modules
Installing FAN08
Modules
210
Figure 128. Disconnecting the FAN08 Module from the Chassis
3. Continue with the next procedure to install a new FAN08 Module.
This procedure requires the following tool:
#2 Phillips-head screwdriver (not provided)
The illustrations show the installation of the fan module in Fan A slot on
the back panel. The procedure is the same for installing the module in the
Fan B slot.
To install an FAN08 Module, perform the following procedure:
1. Align the FAN08 Module in the slot as shown in Figure 129 on page
211.
Advertisement
Table of Contents
