Figure 100: User Exec Mode Prompt - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Note
User names and passwords are case sensitive.
The local management session starts when the User Exec mode
prompt, shown in Figure 100. is displayed.
awplus>
Figure 100. User Exec Mode Prompt
Note
The User Exec mode is the first level in the command mode
interface. For complete information on the modes and commands,
refer to the Software Reference for SBx908 GEN2 Series Switches,
AlliedWare Plus Operating System from www.alliedtelesis.com.
8. Go to "Configuring the Master Switch" on page 160 or "Configuring
Member Switches" on page 166.
SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
159