Table of Contents
Advertisement
Replacing SBxPWRSYS1-80 DC Power Supplies
To replace an SBxPWRSYS1-80 DC Power Supply, perform the following
procedure:
1. Turn off the circuit breaker to the SBxPWRSYS1-80 DC Power Supply.
2. Turn off the On/Off switch on the front panel of the power supply. Refer
to Figure 51 on page 106.
3. Use a #2 screwdriver to loosen the screw on the locking handle. Refer
to Figure 112.
Note
Do not lift the locking handle yet.
Figure 112. Loosening the Screw on the Locking Handle
SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
191
Advertisement
Table of Contents
