Table of Contents
Advertisement
Chapter 7: Cabling XEM2 Line Card Ports
182
Figure 105. Installing an 100Gbps QSFP28 Transceiver in the XEM2-1CQ
Note
If you are ready to attach the fiber optic cable to the transceiver,
continue with the next step. Otherwise, repeat steps 1 to 4 to install
additional transceivers.
5. If the fiber optic connector on the transceiver has a dust cover, remove
the cover.
6. Connect the fiber optic cable to the connector on the transceiver. The
cable is keyed such that it can connect to the transceiver only one
way.
7. Repeat this procedure to install additional transceivers.
Line Card
Advertisement
Table of Contents
