Connecting The Dc Power Wires With The Straight Terminals; Figure 79: Stripping The Power Wires; Figure 80: Attaching The Power Wires To The Straight Terminal Lugs - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Chapter 5: Wiring the SBxPWRSYS1-80 DC Power Supply

Connecting the DC Power Wires with the Straight Terminals

132
To use the straight terminals to connect the DC power wires to the positive
and negative terminals on the power supply, perform the following
procedure:
1. Prepare adequate lengths of two stranded 8 AWG power wires by
stripping them as shown in Figure 79 on page 132.
Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation.  E10
Figure 79. Stripping the Power Wires
Note
You must use stranded wires with the terminal lugs. You may not
use solid wires.
2. Insert the power wires into the terminals included with the power
supply and use a crimping tool to secure the wires to the terminals.
See Figure 80.
Figure 80. Attaching the Power Wires to the Straight Terminal Lugs