Hardware Installation Overview; Table 19: Hardware Installation Procedures - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Chapter 3: Beginning the Installation

Hardware Installation Overview

76
Table 19 lists the general steps to installing the switch hardware.
Table 19. Hardware Installation Procedures
Step Description
1 Review safety precautions.
2 Choose locations for the
switches.
3 Unpack the hardware.
4 Install the hardware.
Procedure
"Reviewing Safety Precautions"
on page 77
"Choosing a Site for the Chassis"
on page 82
"Unpacking the Chassis" on
page 83
"Unpacking SBxPWRSYS2 AC
Power Supplies" on page 88
"Unpacking SBxPWRSYS1-80
DC Power Supplies" on page 89
"Adjusting the Equipment Rack
Brackets" on page 93
"Installing the Chassis in an
Equipment Rack" on page 97
"Installing the Chassis Grounding
Wire" on page 98
"Installing SBxPWRSYS2 AC
Power Supplies" on page 101
"Installing SBxPWRSYS1-80 DC
Power Supplies" on page 105
"Installing Ethernet Line Cards"
on page 109
"Installing Blank Line Card Slot
Covers" on page 113
"Installing the Blank Power
Supply Slot Cover" on page 115
"Installing the Power Cord
Retaining Clips" on page 117