Table of Contents
Advertisement
Installing the Power Cord Retaining Clips
The chassis comes with two power cord retaining clips in the accessory
kit. They are used to prevent the power cords for the SBxPWRSYS2 AC
power supply from being accidentally disconnected from the unit. To install
a power cord retaining clip, press in the sides and insert the ends into the
holes above and below the AC connector. Repeat to install the second
power cord retaining clip. Refer to Figure 66.
Figure 66. Installing the Power Cord Retaining Clips
Note
The power cord retaining clips are not used with the SBxPWRSYS1-
80 DC power supply.
SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
117
Advertisement
Table of Contents
