Figure 102: Disconnecting The Ac Power Cord From The Chassis; Figure 103: Lifting The Locking Handle On The At-Sbxpwrsys2 Ac Power Supply - Allied Telesis AT-SBx908 Installation Manual

2. Move the retaining clip from the appropriate power cord on the rear
panel of the chassis, and disconnect the cord. Refer to Figure 102.
Figure 102. Disconnecting the AC Power Cord from the Chassis
3. Lift the locking hand on the power supply. Refer to Figure 103.
Figure 103. Lifting the Locking Handle on the AT-SBxPWRSYS2 AC
4. Carefully pull on the locking handle to slide the power supply from the
chassis. Refer to Figure 104 on page 180.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Power Supply
179