Ventilation Options; Iaq Reminders - Honeywell Home VisionPRO 8000 Manual

2. Select Mode, Temporary Boost, or Lockout, then
select appropriate options.
Mode
Temporary Boost
Fig. 241.
3. Touch Done to save your settings. Touch Cancel to
ignore changes.
Fig. 242.

Ventilation Options

Mode:
Auto: Ventilation runs as programmed by the installer.
Off: Ventilation remains off unless turned on using the
timer.
On: Ventilation is always on.
Ventilation Mode
Off Auto
Fig. 243.

Temporary Boost: Touch
ventilation temporarily. To turn it off, set it to zero.
Run Ventilation For
60 minutes
Fig. 244.
 
Lockout: Touch or to select Yes or No, then touch Next.
Select Yes to prevent ventilation from running during the
Sleep or Unoccupied (commercial) program periods or
when outdoor conditions exceed values set by the installer.
MCR34133
MCR34134
On
MCR34135

or to select how long to run
MCR34136
Lockout in Sleep
Period:
NOTE: If set up for humidification in heat mode, the venti-
lator will turn on to remove excess humidity if 10%
or more above your humidity setting.

IAQ REMINDERS

You can set up IAQ reminders in the thermostat to remind
users when filters, pads, bulbs, etc. need cleaning or
replacement. The following reminders can be set:
• Air Filter 1
• Air Filter 2
• Humidifier Pad
• Humidifier Clean Tank / Water Filter
• Dehumidifier Filter
• Ventilator Core
• Ventilator Filter
• Electronic Air Cleaner Pre-Filter
• Electronic Air Cleaner Cells
• Electronic Air Cleaner Post-Filter
• UV Bulb 1
• UV Bulb 2
Reminders that are displayed under Preferences will
change based on the IAQ equipment installed. Reminders
for equipment that is already set up can be set using the
steps below. Reminders for IAQ equipment that is not yet
set up must be turned on from the installer setup.
NOTE: Air Filter, Humidifier Pad, Dehumidifier Filter, and
Ventilator Filter are displayed under Preferences
even if they have not been set up. Humidifier Pad
is not displayed if a steam humidifier has been
installed.
Some screens shown in this section may be different from
those on the thermostat, depending on how you set up IAQ
equipment.
1. Press MENU, then scroll to select Preferences.
2. Press Reminders. Fig. 246 is displayed.
97
®
VISIONPRO 8000 WITH REDLINK™
No
MCR34137
Fig. 245.
Fig. 246.
68-0312—06